In November, the pool slowly disappears from everyday life. The sun loungers are put away, the swims are over, and the garden takes on its winter colors. We close the cover, take one last look at the pool, and we say to ourselves that we’ll take care of it in the spring.
Except that in winter, your pool doesn’t really take a break. The cold, the frost, the leaves and the variations in water levels continue to do their work. Some small negligence can turn into painful repairs when the nice weather returns. Here are five mistakes to avoid, without becoming an expert in plumbing.
1. Wait for the first frosts to take care of the pool
We take advantage of the last sunny days, postpone wintering until the following weekend, and one morning we discover frost on the car. The pool, however, has still not been prepared.
The problem is not just the outdoor temperature. It is what can happen in the pipes, skimmers, pump and filter when the water freezes. When it freezes, it increases in volume. If it remains trapped in a device, it can exert a significant pressure on its walls.
The Federation of Swimming and Spa Professionals generally sets the threshold for water to be below 12 °C to begin winterizing. This figure does not mean that unprotected equipment would be protected from freezing as soon as the water exceeds this temperature.
The right approach: monitor the water temperature from autumn onwards, check the local forecasts and prepare the installation before the cold weather arrives. Consult the advice of the Federation of Swimming and Spa Professionals and especially the manual for your equipment.
2. Cut the filtration without protecting the pipes
You want to save electricity during the winter? That’s understandable. But simply turning off the pump without taking any other precautions can be a bad idea.
It all depends on the winterization method chosen. With active winterization, the filtration continues to operate according to a program adapted to the conditions and installation. During freezing periods, an anti-freezing device can automatically trigger the circulation of water.
With passive wintering, equipment is turned off after performing the necessary operations to protect the circuits, notably the purges prescribed by the manufacturer. What should be avoided is a combination of the two: an idle pump, pipes filled with water and a night of intense freezing.
Find the instructions for your installation. The procedures are not the same for an underground pool, a above-ground pool or a cold-exposed technical area. And if you have any doubts about the purge, have a professional take it over. Our article on Active or passive wintering details the differences.
3. Forgetting that the water level keeps changing
A covered pool is not a static pool. In autumn and winter, rainfall can cause the water level to rise. Conversely, a leak or certain evaporation phenomena can cause it to drop.
A too high level can pose a problem depending on the design of the skimmers, the cover and the overflow system. A too low level can also become inconvenient for some equipment. There is no universal height to be respected throughout the winter.
Some installations require a lowering of the level before passive winterization. Others use purging techniques that allow more water to be retained in the basin. Follow the manufacturer’s recommendations and regularly check the level, especially after heavy rainfall.
And above all, never completely empty an underground pool by accident. Depending on its structure and the nature of the terrain, the pressure exerted by the ground or groundwater can cause damage. Our guide on The pool is too full after the rain helps decide what to do.
4. Let the leaves accumulate on the cover
In November, the trees lose their leaves. They end up on the terrace, in the gutters and on the pool cover. At first, it's nothing dramatic.
But when they accumulate, the leaves retain moisture and decompose. With the rain, they sometimes form a heavy layer that is difficult to remove. Depending on the cover model, this accumulation can also interfere with the drainage of water.
And when a cover is poorly attached, the wind can cause friction and accelerate wear. There’s no need to take out the broom every morning. However, after a storm or several windy days, check the condition of the cover and remove any debris that is accessible without getting on top of it.
Attention: not all covers are designed to support the weight of a person. You must strictly follow the manufacturer’s instructions. And never consider a simple winter cover to be an approved safety device if it is not.
5. No more looking at his swimming pool until spring
The basin has been properly prepared. Everything seems to be in order. Therefore, we consider the work to be complete until April. However, a few checks during the winter can prevent any unpleasant surprises.
After a period of freezing, check if any visible equipment is showing any abnormalities. After a storm, check the fixing of the cover. After heavy rainfall, check the water level.
If you are undertaking active wintering, ensure that the filtration and anti-freezing protection are operating in accordance with the intended settings. Regular visual inspection is often enough to spot emerging problems. It is not a matter of taking the pump apart every Sunday; it is just a matter of keeping an eye on an installation that remains outside for several months.
If you notice a leak, an unusual noise, or equipment damaged by freezing, avoid forcing it back into operation until the problem has been identified.
The little check to be done before the next cold wave
Do you have five minutes this weekend? Simply take a tour of your installation. Check that the coverage is properly fixed, that the water level corresponds to the recommendations of your winterization system, and that the equipment exposed to frost is protected.
If your filtration system remains active, check its settings and the operation of the device when it is not freezing. Also check the weather forecasts. A pool located in the Var does not experience the same conditions as a pool installed in Lorraine or the Jura region. Even in a region considered mild, a sporadic cold spell remains possible.
The goal is not to multiply unnecessary interventions. The goal is to detect problems before they become serious.
In the spring, you will be glad you took these precautions.
A swimming pool is an important investment. It would be a shame to spend the first beautiful days repairing equipment that could have been protected.
An adapted wintering period, some checks after the storms and a minimum of attention during the cold months: this is a good foundation for getting your pool back in good condition. When the sun returns, we prefer to think about the first swim rather than the repair bill.