It rained all weekend. On Monday morning, you take a look at the pool and discover that the water is almost at the edge. The leaves float everywhere, the skimmer disappears under the water and your dog seems to find that much more interesting than you.
First reaction: you need to drain some water. But how much? With what? And most importantly, is it necessary? A pool that slightly overflows after a storm is not necessarily a disaster. However, letting the level rise without checking the installation can create problems.
Why the level rises so quickly after the rain
A swimming pool is a large area open to the sky. Let’s take a basin measuring 8 meters by 4: that’s 32 square meters. If 30 millimeters of rain falls, it theoretically receives an additional 960 liters. With 50 millimeters, that’s 1,600 liters. This calculation assumes that no water has drained away during the event.
In regions where several rainy episodes follow one another, the level can rise rapidly. With a spillover, a flood, or a specific cover, the operation may be different.
The skimmer, your best indicator
Look at the opening of the skimmer, which sucks up surface water to recover leaves and small debris. The recommended level depends on the equipment: some manufacturers recommend about three-quarters of the opening height, others a slightly different reference point. Check your manual.
If the water completely submerges the opening, the skimmer may not be able to capture the floating waste as well. Too low, on the other hand, the level may cause air to be sucked into the pump. The right level is not the one that fills the pool the most, but the one that allows your system to operate properly.
Should we intervene immediately?
Not always. If the water has gained a few centimeters and everything is working normally, start by monitoring it. But if the skimmer is completely submerged or the water overflows onto an area to be protected, you need to consider restoring the recommended level.
First, check if the pool has a backflow prevention system. This system drains the excess water from a certain height. If it seems ineffective, look for any obstruction; do not disassemble the components of the system blindly.
How to remove some water without doing anything stupid
With a filter valve
On certain installations equipped with a sand filter and a multi-way valve, it is possible to discharge water to a dedicated outlet. You must follow the instructions: with a conventional multi-way valve, stop the pump before changing its position. Monitor the level and avoid the pump sucking air.
With a vacuum pump
An adapted pump can remove excess water when the filtration system does not have an appropriate function. Again, this is not about emptying the basin; it is simply about restoring the recommended level.
Beware of water rejection
In France, Article R1331-2 of the Public Health Code regulates the discharge of wastewater from swimming pools into wastewater collection networks. Discharge is generally prohibited, except for exceptions under specified conditions. The options for discharge into other networks or onto land depend on local regulations. Consult the sanitation service before pumping, and do not discharge the water to a neighbor or into a ditch without permission.
Can rain regulate water?
Yes. Rainwater can alter the pH and alkalinity of the basin, depending on the volumes received and the composition of the water. This does not mean that you have to automatically add corrective products after each rainfall.
Measure before you treat. When the filtration is working normally, let the mixture work itself out; then check the pH and the disinfectant with suitable tests. If the values are satisfactory, there is no need to repeat the treatments.
And the leaves that float everywhere?
After the rain, the wind often causes the leaves to fall. Remove as much of them as possible from the chute. Remove the basket from the skimmer and check the pre-filter of the pump if your system has one.
A clogged basket can hinder the flow of water. And if you’ve left your robot idle for a while, don’t ask it to swallow a mountain of muddy leaves. A small manual pass will do just fine.
For the usual maintenance tasks, discover also our real-time guide on maintaining a swimming pool.
Winter swimming pool: the rules are changing
In active hibernation
The filtration continues to function, often at a reduced rate according to the manufacturer’s instructions and the risk of freezing. The level must remain compatible with the skimmers, other water outlets, and equipment. After a heavy rain, an adjustment may be necessary, but without excessively lowering the water level.
In passive hibernation
The filtration is stopped and the equipment is protected. The level may have been lowered according to the procedure followed. If the rain causes it to rise again, check the protections and the instructions for your equipment. Be careful with submerged shutters, covers, and systems that require a precise water line: there is no universal guideline.
Above all, do not completely empty the pool
A major drain is not trivial. In a buried pool, the water in the basin contributes to the balance of the pressures exerted on the structure. When the outdoor area is saturated with water, a drain can increase the risks, especially for some concrete pools.
Never perform a major drain without the appropriate instructions from the manufacturer or professional advice. The goal after the rain remains to correct an excessive level, not to redo a complete water refill.
One last piece of advice before heading back inside
After a heavy rainy episode, give your pool a few minutes to recover. Check the water level, remove the leaves, check the baskets, and make sure the overflow works if you have one.
You don’t need to bring out all the equipment of a perfect pool operator. And you don’t need to adjust the pH or pump several cubic meters because it has rained for two days. The key is to know the level that suits your installation and to keep an eye on it.
You can then return to warmth. The dog, on the other hand, will probably have already taken off his raincoat.
Sources
Public Health Code, Article R1331-2 ; Federation of Swimming and Spa Professionals, Maintenance and winterizing tips. The recommended levels depend on your skimmer’s manual and your installation.